Tmax XT UL Catalogo [EN]

4/21

COMMUNI CAT ION AND CONNECT I V I T Y

Ekip 10K Signalling unit The Ekip 10K Signalling unit is an external device designed for DIN-rail installation. The unit provides ten contacts for electrical signaling of timing and tripping of protection devices. If connected via the Ekip Connect software, the contacts can be freely configured in association with any event and alarm or combi- nation of both. Several Ekip 10K Signalling units (max 4) can be used at the same time on the same Ekip trip unit. The Ekip 10K Signalling module can be powered either by direct or alternating current and can be connected to all the trip units via internal bus or Ekip Link modules.

— Ekip 10K Signalling unit

Ekip Signalling Modbus TCP It is an external signalling unit designed for DIN rail installations. The function of the signalling module is to share - via an Ethernet network with Modbus TCP communication protocol - information about the state of circuit-breakers that might not have the ability to provide such information via Ethernet, and also to allow these circuit-breakers to be operated via remote control.

Output contacts characteristics

Number of contacts

Type

Monostable

Ekip 1K

Ekip 2K

Maximum switching voltage Maximum switching current 30V DC

150V DC / 250V AC

— Ekip Signalling Modbus TCP

2A

50V DC 150V DC 250V AC

0.8A 0.2A

1 output + 1 input

2 output + 2 input

4A

Contact/coil insulation

1000 Vrms (1min @50Hz)

Ekip 10K/Ekip Signalling Modbus TCP power supply Auxiliary supply

24-48V DC, 110-240V AC/DC 21.5-53V DC, 105-265V AC/DC

Voltage range Rated power Inrush current

10VA/W

1A for 10ms

Signaling contacts for the XT7 and XT7 M Ekip trip units With XT7 and XT7 M circuit-breakers, the Ekip trip units can acquire the status of the circuit-breaker ready to close (RTC) and racked-in, test, or racked-out position through the optional Ekip RTC and Ekip AUP sig - naling contacts. These contacts, housed in the accessories area of the circuit-breakers, are available with the Ekip Dip and Ekip Touch/Hi-Touch.

— Signaling contacts for Ekip trip units

Powered by