SACE TMAX XT UL/CSA LOW VOLTAGE MOLDED CASE C I RCUI T- BRE AKERS UL4 89 AND CSA C2 2 . 2 STANDARDS
4/28
— Accessories for XT2-XT4 Ekip trip units Compatible with Ekip LSI and Ekip LSIG trip units for the XT2 and XT4 sizes
Ekip Display The Ekip Display is a unit that can be applied on the front of the solid-state trip unit and shows the current values, alarms, and protection settings. Main features: • Installation : The Ekip Display can be easily installed on the front of the Ekip LSI and Ekip LSIG electronic trip units. It is connected by means of the test connector on the front of the trip unit, and fixing is simple and reliable thanks to a specially designed mechanism. This mechanism also provides a practical way of fastening the accessories to the circuit-breaker to prevent undesired access to the dip-switches. Installa- tion can be carried out under any condition, even with the door closed and the electronic trip unit already on and functioning. • Functions : The Ekip Display has four buttons for browsing through the menus. It functions in self-supply mode starting from a current of I>0.2xIn circulating through at least one phase. Backlighting is activated in the presence of higher loads, thereby allowing better legibility of the visualized information. Rear lighting comes on in self-supply for a current of I>0.4xIn and is always on when there is an electronic trip unit auxil- iary power supply. The Ekip Display: - shows the current, voltage, power and energy values; - shows the settings of the protection functions in Amperes or in In; - shows the protection that has caused the trip unit to trip and the fault current (only when there is 24V external voltage or the Ekip TT unit); - allows the trip thresholds of the trip unit to be programmed and the communication parameters to be set on the bus system. • Compatibility : The Ekip Display can be fitted even when the front accessories, such as the motor or direct and transmitted rotary handles etc. are already installed. It is possible to use Ekip TT or Ekip T&P without removing the Ekip Display. Ekip LED Meter The Ekip LED Meter can be applied to the front of the electronic trip unit and displays the current values and alarms. Main features: • Installation : The Ekip LED Meter can be easily installed on the front of Ekip LSI and Ekip LSIG electronic trip units. It is connected by means of the test connector on the front of the trip unit and fixing is simple and reliable thanks to a specially designed mechanism. This mechanism also provides a practical way of fas- tening the accessories to the circuit-breaker to prevent undesired access to the dip-switches. The instal- lation can be carried out under any condition, even with the door closed and the electronic trip unit al- ready on and functioning; • Functions : The Ekip LED Meter provides an accurate indication of the value of the current circulating in the trip unit by means of a scale of LED. Their different colors allow normal operation, pre-alarm and alarm states of the circuit-breaker to be recognized at a glance. It is active in self-supply mode from a current of I>0.2xIn circulating through at least one phase or when the auxiliary power is available for the electronic trip unit; • Compatibility : The Ekip LED Meter can also be fitted when front accessories, such as the motor, direct and transmitted rotary handles etc. are already installed. It is possible to use the Ekip TT or Ekip T&P without removing the Ekip LED Meter. It is not possible to use the Ekip LED Meter with a withdrawable breaker version.
— Ekip Display
— Ekip LED Meter
Powered by FlippingBook