SACE TMAX XT UL/CSA LOW VOLTAGE MOLDED CASE C I RCUI T- BRE AKERS UL4 89 AND CSA C2 2 . 2 STANDARDS
7/46
— Remote control
Stored energy motor operators - MOE and MOE-E XT5 and MOE XT6
Signaling of the springs status: charged springs/discharged springs
LED power-ON
Signaling of the circuit-breaker status ON-OFF
Lever to recharge the springs
— Stored energy motor operator (MOE)
Opening push-button
AUTO-MANUAL-LOCKED selector
Sliding cover for AUTO mode
Closing push-button
Position for the optional locks
Slot for padlock device
The MOE or MOE-E stored energy motor operator available for the XT5 and XT6 is supplied: • with 3.28 ft long cables; • with connectors for the fixed part and moving part of withdrawable devices. If the motor operator is used with fixed or plug-in circuit-breakers, the connector can be easily removed; • with a flange, to use instead of the standard one supplied with the circuit-breaker; • with a padlock device, only removable when the motor is in the open position. The padlock device ac- cepts up to three 0.3in padlocks; • with a lock for the AUTO-MANUAL selector; • with auxiliary contacts that allow the motor control mode (manual or remote) signal to be routed outside; • (on request) the motor operator can be equipped with a key lock (see the Chapter "Accessories" - section "Locks"); • (on request) the motor operator can be equipped with a key lock to safeguard against manual operation (MOL-M) (see the Chapter "Accessories" - section "Locks"). Operating principles: • a selector on the front of the MOE, is used to select the operating mode: - AUTO: when the selector is in this position, the push-buttons on the front of the motor are locked and covered by a sliding cover. It is possible to seal the sliding cover to avoid mode changing. Circuit-breaker closing is commanded remotely only by means of an electric impulse, whereas opening is allowed both remotely and from the front of the motor using a tool; - MANUAL: the circuit-breaker can only be opened/closed from the front of the motor using the relevant push-buttons. It is possible to seal the sliding cover to avoid mode changing; - LOCKED: the device can be used only if the motor is in the open position and the springs are charged. The padlock device can be withdrawn and the can be motor locked in the open position; • operation of the motor operator via remote control is also guaranteed by permanent electrical opening/ closing impulses. Once an opening command has been given, the next closing command (permanent) is taken over by the motor operator once the opening has been completed. In the same way, an opening command is taken over once the previous closing operation has been completed. When the Ekip Commodule is used, the MOE-E motor operator must be used instead of the MOE motor op - erator. The MOE-E allows digital signals from the supervision and monitoring system to be used by means of the release and Ekip Com contacts and to be converted into power signals to command the motor operator. All the features described above for the MOE motor operator are also available on the MOE-E version.
Powered by FlippingBook